Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Los Angeles Owner’s Guide

Ghost Controls keypad and intercom repair in Los Angeles typically runs $165 – $395 installed, depending on whether we’re replacing the keypad, the intercom module, or both, and we carry compatible units on the truck for same-day service in most cases. The usual story we hear is this: the keypad stopped lighting up, or the intercom crackles and drops the call, or a power surge after a Santa Ana wind event fried the board inside. You’ve got a Ghost Controls opener that still works fine, but the entry side of the system has gone quiet.

Call (213) 322-0062

Key Takeaways

• Most Ghost Controls keypad and intercom failures happen in the weather-sealed external unit, not the opener itself.
• We stock OEM Ghost Controls parts plus proven aftermarket equivalents that match the AXDP, TSS1, and newer Ghost Controls wireless models.
• You’ll get a written price before we turn a single screw, and the repair carries the 365-Day Done Right Promise.

Which Ghost Controls Models This Applies To

Ghost Controls makes three main entry-access lines that we service in Los Angeles: the wired keypad models that mount on a gooseneck or pedestal, the wireless AXDP and TSS1 keypads that pair to the opener’s receiver, and the AXDP1 intercom-plus-keypad combo units you see on newer driveway installations. Each one has its own failure pattern and its own compatible replacement parts, and the biggest gotcha we run into is this: the wireless keypad and the intercom module may share a housing, but they’re separate circuit boards with separate part numbers.

Here’s the compatibility detail that saves you money. Ghost Controls keypads are not universal across the brand. A keypad made for the TDS series won’t reliably pair with the TSS1 receiver unless it’s flashed for that protocol, and we’ve had too many Los Angeles homeowners order the wrong board online and wait a week for a part that never syncs. OEM Ghost Controls parts are solid, but for the older wired keypads that Ghost Controls no longer manufactures, we stock quality aftermarket equivalents that meet the same voltage and weather-sealing specs. The unit’s model sticker is usually on the back plate or inside the battery compartment. Snap a photo of it before you call, and we’ll match it to the right part the first time.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad lights but won’t accept the code. This is almost always a worn membrane or a failed logic chip inside the keypad housing. The buttons register physically, but the signal never reaches the opener’s receiver.
• Intercom static, buzz, or dropped audio. Los Angeles coastal fog and inland heat both accelerate corrosion on the intercom’s speaker and microphone contacts. What starts as mild static usually ends as a dead call within a few months.
• Keypad works intermittently after rain. The weather gasket has failed. Water gets inside, the board corrodes, and the unit works again once it dries out. That cycle shortens the life of the board dramatically.
• Visitor presses the call button and hears nothing. The intercom’s relay that triggers your indoor call station has burned out. The doorbell button itself is rarely the culprit.
• Gate opens on its own or won’t close after a call. We see this most with the combo intercom-plus-keypad units, where a failed relay sends a phantom open command to the opener.

Replacement Cost & What’s Included

For a straight keypad swap in Los Angeles, you’re looking at $165 – $275 installed. A keypad-plus-intercom replacement lands between $295 and $395, depending on whether we’re rewiring the pedestal or mounting a new unit with fresh weather sealing. If we’re replacing a Ghost Controls TSS1 wireless keypad, expect to pay around $185 – $260. Those numbers include the part, the labor, the programming, and re-sealing the unit against moisture. If your existing wiring needs replacing, we’ll show you the condition of it and quote the new run separately before we touch it.

Every Ghost Controls keypad and intercom repair comes with the written Kingswell Guarantee: a real arrival window, a clean job site, and a 365-day written warranty on the repair. If the keypad or intercom fails inside that year, we come back and make it right at no charge. That’s the 365-Day Done Right Promise, and it’s stamped on your invoice, not just mentioned in a brochure. The price you approve before we start is the price you pay when we finish.

DIY or Call Us?

There are two things you can safely check before calling us. First, verify the keypad intercom has power: if it’s wired, check the breaker or transformer; if it’s wireless, replace the battery with a fresh one and re-test. Second, look for obvious physical damage to the faceplate, gasket, or the wire run where it exits the pedestal. Rodents in Los Angeles love chewing through low-voltage wire, and that damage is easy to spot. Beyond that, we recommend against opening the housing on an intercom combo unit. These boards carry enough residual voltage to damage a new replacement if you short the wrong pin, and the weather sealing you disassemble is difficult to get right again. We’ve seen plenty of DIY attempts in Los Angeles that turned a simple $200 keypad swap into a shorted board on the opener side. Call (213) 322-0062 and tell us what the gate is doing or not doing. Dean Prescott will give you a real number before we even pull out of the driveway.

FAQs